User Manual 11 < back to the table of contents > 4.4 LED Status Indicator DThe three LEDs of a DAT-Module are organized into three priority levels, with Priority 3 being user configurable. For more information on how to configure this priority, refer to Chapter 10 Alarm. Priorities 1 and 2 are reserved for identification, Bluetooth Low Energy (BLE) connection, and voltage status. Status LEDs LED X1 LED X2 LED X3 Priority 1 X1 X2 X3 Yellow flashing LED X1-X3: Identification starting from the COM Yellow flashing LED X1-X3: Identification starting from the COM Yellow flashing LED X1-X3: Identification starting from the COM X1 X2 X3 – Green flashing (for 5 sec.): Connected – X1 X2 X3 – Yellow flashing: Pairing but no connection – X1 X2 X3 – Red flashing: No pairing and no connection/error – Status LEDs Priority 2 (5 seconds after connection with the COM-Module) – Off: Single Phase – When inactive phase Off: Single Phase – When inactive phase Off: Single Phase – When inactive phase X1 X2 X3 Red: No voltage (<200V) Red: No voltage (<200V) Red: No voltage (<200V) X1 X2 X3 Green: Voltage ok (>200V) Green: Voltage ok (>200V) Green: Voltage ok (>200V) Status LEDs Priority 3 (Can be set by user) – Link to measured values and/or alarm items Link to measured values and/or alarm items Link to measured values and/or alarm items Figure 8: LED Status Indicator – DAT-Module
RkJQdWJsaXNoZXIy MTAxNzE=