User Manual 54 < back to the table of contents > 3. SMTP Server Port: Specifies the SMTP port. Port 587 is used by default. 4. Authentication: Enables or disables authentication for the SMTP server. 5. SMTP Account Username: The email address of the account used for authentication. 6.6 SMTP Account Password: The password for the account. Configuring Email Sending via SMTP: After activating the email service, a connection to an SMTP (Simple Mail Transfer Protocol) server must be configured to enable email sending. 1. Create an Email Account First, create an email account with any provider that supports access to an SMTP server. 2. Have Login Credentials Ready Make a note of the login credentials (email address and password), as well as the SMTP server address and the corresponding port provided by the email provider. 3. Configure the Connection Enter the SMTP server address, port, and login credentials into the corresponding fields in the configuration interface. Ensure that authentication is enabled and, if necessary, that a secure connection (SSL/TLS) is used. 4. Set the Sender Address Finally, enter the email address that should be used as the sender of the messages. Once the configuration is complete, the email service can be used to send messages via the specified SMTP server. Changes will take effect after restarting the software. You can verify the email service by sending a test message. To do this, enter the desired recipient’s email address and click “Send Test Message”. If debugging is enabled, additional debug information will be displayed. Figure 60 shows the widget for sending a test message. Figure 60: Sending a Test Email 12.4.4 Database Configuration To store data from the COM-Module and one or more DAT-Modules on the COM-Module and to visualize this data under the “Historical Data” tab, the database must be activated. After restarting the software, the changes will take effect, and measurement data will be stored in the database on the COM-Module Figure 61: Activating the Database
RkJQdWJsaXNoZXIy MTAxNzE=